Enhancer

Features + Benefits
Easier to use
Richens color
Standard protection against all stains
Water-based
Interior use

Where to Use
Natural stone such as marble, limestone, slate, travertine, sandstone, flagstone,
tumbled stone, flamed stone & textured stone. Masonry & concrete.

Directions
Note: Directions may vary by size. Always test in a small inconspicuous area with
a 24-hour cure time to determine ease of application and desired results. Allow
new grout installations to cure for a minimum of 72 hours prior to application.
Make sure surface is clean, thoroughly dry and free of waxes and coatings. Not
recommended for exterior surfaces.

Mask off and protect any baseboards or adjacent areas to avoid splashing and
overspray onto surfaces not intended to be treated.
Liberally apply an even coat using a paint pad, low-pressure chemical-resistant
sprayer, roller or brush.
Allow to penetrate the surface for 15-30 minutes; denser material may require
maximum time for Enhancer to penetrate. During this time, distribute excess over
entire area to insure even penetration. Completely wipe surface dry. DO NOT ALLOW
ENHANCER TO DRY COMPLETELY ON SURFACE.
A second coat may be needed for porous, absorbent surfaces or if a darker
appearance is required and should be applied one hour after initial application as
directed in steps 2-3.
A full cure is achieved after 24-72 hours; foot traffic may begin in 6-8 hours.
Cover with red rosin paper, if foot traffic must resume before the recommended
time periods have passed.
Clean equipment with water.
Available Sizes (and Coverage)
Quart: 50-300 sq. ft.
Gallon: 200-1,000 sq. ft.
Expected Wear: 3-5 years. .